Change language
|
ROCHEM Fyrewash Ltd
5-6 Sun Valley Business Park
Winnall Close, Winchester
Hampshire
SO23 0LB
ROCHEM Fyrewash Inc
23707 West Hardy Road
Spring
Texas
77373
06.02.20
Hand on heart, nobody enjoys cleaning. However, most of us will freely admit to preferring a clean and tidy house to a messy one: it’s easier to find your keys, you don’t trip over things and the whole place just functions better!
That said, most houses require a fair amount of effort to maintain, but are much easier to keep in check once a regular cleaning schedule is in place.
Some people manage this by having it vaguely in mind that there is bleach in one of the under-sink cupboards, having never seen nor used it.
Others have the occasional big spring clean then keep to a regular timetable to tackle each room. Given the choice, I know whose bathroom I would prefer to use.
The principals of an effective house-cleaning timetable are basically the same for your compressor.
Regular, scheduled washes interspersed with deeper cleans are the best way to keep your at its peak.
Cleaning in this way is much easier to manage and gives far better results than sporadic washes when the need becomes urgent.
All that goes into your compressor is air and gas, so it can be hard to imagine how it could possibly get dirty.
The problem is that the air inevitably carries tiny impurities such as pollution, salt, and sand.
Under high heat and pressure these are deposited on your compressor blades and ‘bake’ in place. This in turn interrupts the fine-tuned airflow with a knock-on effect for efficiency.
Basically if your process compressor is left dirty you will spend more and more on fuel to run a system that does not give you the output it should. Ultimately, you are likely to face unplanned shutdowns due to system failure.
How you keep your house clean (and how clean you keep your house) is not our business.
We specialise in all things relating to
Essentially though, the fundamentals are the same: if you use the right products and equipment while following a sensible schedule, you will get great results.
The great news is that you can use the same and equipment for both on and off-line cleans, saving money and administration.
Compared to a compressor caked in foulants, a clean compressor works more efficiently and an efficient compressor is cheaper to run.
In fact, the initial outlay on equipment plus the cost of regular compressor washes is dwarfed by the savings of improved efficiency.
As an added bonus: not only do you but you enjoy a more reliable system.
Unscheduled shutdowns are far less likely when your compressor is clean and your turbine is performing at its best.
If Kim and Aggie created the show: ‘How Clean is Your Compressor?’ then this is what they would tell the poor, embarrassed mechanics:
Do not do anything that is not in the OEMs. Check any cleaning hardware or chemicals you want to use and get the thumbs up.
Clean up after your cleaning by making sure you carefully document and report waste (if necessary) and are responsible with collection and disposal.
Not only is this important for the environment but you could face fines for improper practise.
Tap water might look clear but it can have all sorts of impurities dissolved in it.
The very best tip for great results is to use pure water for cleaning and rinsing.
Deionised or demineralised water is ideal as it won’t introduce further contaminants to the system.
Sorry, we won’t come round to your house and help with your spring clean. However, we can help you set up an effective and schedule for your gas turbine compressor.
Getting started can seem daunting but the benefits of an efficient, reliable turbine are well worth it. We can offer guidance at every stage as well as recommendations for a range of professional products trusted by customers around the world.
If you have got any questions or would like to find out more about how we can help, .
We promise we will be much kinder about cleanliness than Kim and Aggie!
Post written by Martin Howarth
An extensive knowledge of mechanical and electrical engineering together with hands on experience with gas turbines provides a bedrock for his work at Rochem.
