Change language
|
ROCHEM Fyrewash Ltd
5-6 Sun Valley Business Park
Winnall Close, Winchester
Hampshire
SO23 0LB
ROCHEM Fyrewash Inc
23707 West Hardy Road
Spring
Texas
77373
03.22.23
It’s almost unthinkable now but, not so long ago, fuel costs were low and power plants were built without worrying about the expense of running them. Today, the , and gas turbine powered plants are becoming more and more costly to keep in business.
If this sounds familiar, you may be facing the decision of whether or not to upgrade to a more modern, efficient power plant. Yes, it’s a huge outlay but those fuel prices are becoming cripplingly high which makes the investment tempting. You can’t carry on as you are, after all.
However, we’re here to tell you there’s another option. You don’t necessarily need … perhaps you could cut costs, improve reliability and extend your plant’s lifespan for a mere fraction of the outlay. Perhaps we can help…
In around 1998 natural gas was cheap and gas turbine powered plants were built quickly without too much concern for efficiency. Owners wanted to cash in on inexpensive fuel and this building boom lasted until the end of 2003. Today, now that gas prices have massively increased and show no signs of dipping, we are stuck with inefficient power plants that use way more fuel than they should and owners are struggling with the huge gas bills eating into their profit.
Even a plant that’s 20 years old can work without real fault, but that doesn’t mean it’s efficient and cost effective. Many power plant owners are choosing to make partial or full upgrades at their sites at huge expense.
If they don’t realise that they can boost efficiency for a fraction of the cost, they probably feel that they have no other option. However, there are ways to boost efficiency without significant outlay, making your plant much more profitable and reliable.
It’s not an industry secret but plenty of power plant owners don’t realise there is a significantly cheaper alternative to spending a fortune on equipment upgrades. The answer is effective gas turbine compressor cleaning, and we can help.
If your power plant is essentially in good running order, if a little dated, there’s probably no need to go to extreme and expensive lengths just yet. By implementing an effective , you will remove which otherwise build up and interfere with air/gas flow.
Maintaining a clean, aerodynamic compressor means gas more fully combusts and you get the most from every atom that enters your turbine.
At Rochem, we’ve been designing and making equipment and for over 40 years. Our products help customers regain lost efficiency while increasing the reliability of their equipment. Another bonus is that our products can help your plant run more ‘greenly’, meeting emissions targets and .
Customers find that the small outlay on cleaning equipment and/or our specialised cleaning chemicals is regained many times over, without the need to even consider upgrading their power plant.
While we can’t reduce the cost of the gas itself, we can help you get the most from that gas meaning you don’t spend money on expensive fuel only for it to go to waste. Essentially, we can help you fully utilise the equipment you already have.
If you’re interested in finding out what we could offer for your site, please . Our experienced, knowledgeable team are here to answer all your questions.
Post written by Martin Howarth
An extensive knowledge of mechanical and electrical engineering together with hands on experience with gas turbines provides a bedrock for his work at Rochem.
